#Iei keypad change code pdf
#Iei keypad change code manual
#Iei keypad change code code

#Iei keypad change code manual

The manual covers the features, specifications, wiring, mounting, and troubleshooting of the keypad.

#Iei keypad change code pdf

This warranty shall expire two years after shipping date for DOOR-GARD keypads.Įxcept as stated above, IEI makes no warranties, either express or implied, as to any matter whatsoever, including, without limitation to, the condition of its products, their merchantability, or fitness for any particular purpose. Instruction Manual 212iLW - Amazon Web ServicesThis PDF file provides detailed instructions for installing and programming the 212iLW keypad, a stand-alone access control device that can operate a single door or gate. IEI will not be liable to the purchaser or anyone else for incidental or consequential damages arising from any defect in, or malfunction of, its products. IEI’s sole liability is limited to the repair or (at IEI’s option) the replacement of the defective product or part when sent to IEI’s facility (freight and insurance charges prepaid), after first obtaining IEI’s Return Merchandise Authorization. IEI does not assume any responsibility for damage or injury to person or property due to improper care, storage, handling, abuse, misuse, normal wear and tear, or an act of God. (IEI) warrants its products to be free from defects in material and workmanship, when they have been installed in accordance with the manufacturer’s instructions, and have not been modified or tampered with.

On SE keypad, holes have also been spotted inside the front housing for additional LEDs (LEDs not included).

To speed installation of the SE keypad, holes have been spotted on the inside the back housing for mounting to a wall or a single-gang electrical box. Resetting the Keypad Command/Action Keys to Enter/Details Reset Defaults Only 40 00000 00000 Reset Entire Keypad 46 00000 00000 Note: This does not reset the keypad operating mode.

For use in extreme weather conditions, consult the factory for additional methods of protecting your keypad.

This allows air to circulate and a place for condensation to drain.

Do not seal the drain holes at the bottom of the keypad housing.

Do not silicone the cover plate because the unit will not seal properly. Supports 500 users in stand-alone mode, more when using Linear. Program and maintain all of your access control data within the keypad in stand-alone mode, or have the MiniMax 3, Max 3, or a Wiegand controller make the access control decisions, and use the 2000eM as the front-end keypad.

#Iei keypad change code code

This helps prevent water from entering the case and condensing on the circuit board. Key press feedback via built-in sounder and yellow LED. When you enter a code on the keypad it is then sent to the control panel as Wiegand card data, depending on which format you’ve programmed it for. When mounting this unit outside, apply silicone to the area where the wires enter the case.The bi-color LED provided with the SE keypad illuminates red when the LockRelease relay is de-energized and green when the relay is de-energized.

To avoid ESD (Electro-Static Discharge) interfering with the operation of the keypad, ground the housing to earth ground.